Recent content by blkhunter01

Who makes the best race ready and legal lol wheels and axles?

If I bend the DFW 7-9 degrees will it lift the NDFW off the track? Is so should I drill NDFW Ar zero and use a 3 degree bent axle there?

I plan to put 1/64 ply on top of the weight pocket area after getting the body down to 1/4 thickness I use a scroll saw for cutting all the way through the body.

I have just woken up from a drinking induced nap and figured the dream I had about shaping/sanding the bodies squarely and quickly down to 1/4-.025 could be done. How about an aluminum sheet 1/2 inch thick 8 inches long 2 1/2 inches wide with hardened 1/4 square steel bar stock epoxied to the...

Dramatic explanation there jimmy

Redesign is done have a little bit of sanding to do to make it look nicer. Also you am unsure of how to profile the front? Any suggestions?

Good question are there any machinists on the forum? I have an idea?

Ok taken that into account and I drew out about body getting ready to cut it out as soon as amazon delivers my new scroll saw blades

I won’t be ever taking the cars I build apart. They are like trophies in themselves.

Loots of views no feedback, i need some advice!

My first attempt at ladder body still need to shape the front nose section to a point.

EBAY body I got for reference

DD4H sugar pine block

To secure weights to ladder car, not going to be reusing them want a permanent solution.

That helps a lot. Question why not use the monokote on the bottom also if it is weightless? Vs packing tape?