Recent content by BulldogRacing

First cut K house grooves in the axle heads so it'll help you back out the axles while you apply very light pressure. If you need to pull hard you'll destroy the wheels. This picture shows slots I used to cut in the body to remove axles with a small screwdriver, I now relax the holes so the...

Ask around here for some bearings and and razors that did not make the cut for us and you may get some discounted parts that will make your fellow workers heads spin.

Hack saw blade after the holes are drilled or a band saw with a steady hand.

They'll be faster.

Just clean the treads.

I had some wheels sit for a year and they were fast as heck when we took them out this year, I'm talking .005 faster than last year on the same car!

Prep a back up set just in case, the liquid glass will be fine it's just not as good as the Black Ice.

Sugar pine for me.

5-6 grams

My cars have run with and with out a cross beam, I have noticed the monocoat stays more flat when i have a cross beam but the speed is no different.

B reg has been smoking some oil, LOL!

Try this link my friend www.npwdrl.boards.net

Longer the better!

Q.T took the NPWDRL track to a local machine shop to have the ends machined perfect so they could mate exact. You may look into that option, I believe the fee was very reasonable. My sanding block was very short, but longer would be better, I just had 6" sanding discs so I made that work and...