Recent content by zippo3359

So, if I do a rail runner (I'd lift the non-dominant wheel as that is allowed by our rules) and I use a silver bullet to drill out the axle holes, would I use the slot closest to the top where the block goes in for the rear wheels and the slot at the bottom (opposite the place where the block...

We are able to drill out the pre-cut slots. Though that isn't stated in the rules, it is encouraged at the workshops the pack holds.

So, this is our second year racing and last year we did little to no speed prep other than some hobby graphite on the axles. We ended up with the CoM much to close to the rear (behind or right above the rear axles) and had a deadly shimmy in the front end due to the lack of weight. We were a...