Thinking about building a Street Stock AM car

[The Iceman]

So would a good start be

1. 2010 Nationals Workshop on DVD! Unlock The OIL SECRETS!
2. The Dynasty Cheetah v.3 set of 4 wheels
3. Krytox GPL 100 Oil + DerbyDad4Hire Secret Mix
4. The Dynasty 92X Pro Axle
5. rear fenders?

Thanks

 

[AC Designs]

Red Rocket
Front Fenders
Axle and wheel bore polishing kit
Derlin washers
Get one of the axles bent
Are you doing your block, if not get one from John and have it drilled for you.

 

[The Iceman]

Red Rocket
Front Fenders
Axle and wheel bore polishing kit
Derlin washers
Get one of the axles bent
Are you doing your block, if not get one from John and have it drilled for you.

I have the red rocket, bore polish, block and will probably make my own Fenders, i have some Teflon sheets I'm going to try. Are the Derlin washer better? And what is the standard wheel base with fenders in front and back? When they say Stock they don't mean stock wheelbase do they?

Thanks

 

[bracketracer]

You can run whatever wheelbase you would like Iceman.

Here's the rules: http://npwdrl.com/rules/street-stock-rules/

I like 4 3/4", others go longer. I think 5 or 5 1/4" is about as far as you can go and still fit front fenders on easily. Depends on how far forward you drill your rear axle holes.

 

[AC Designs]

My new street stock is 5in. and the front fenders fit just right. I would go over 5 1/4 fitting fenders on the front might be tricky. Get that car finished and join us this month for the race.

 

[~JBD RACING~]

5 inch is the max for the GEE FENDER, I have few 5 1/4 with wooden front fender that I had no trouble installing..

 

[GravityX]

5" is the max wheelbase assuming that the rear axle placement is at 5/8" from the rear. Anything more than 5/8" and you have to subtract that amount from the wheelbase to still have room for a GEE Fender. Super small fenders ahead of the front wheel are tough to build, but can be done.