What size pin for 1.5 degree cant

[shmrckx]

Long time lurker... Great info on this site. Thanks to you all for sharing.

I did a search but could not find an answer. What size pin/drill blank should you use with the silver bullet to get 1.5 degree cant on the rear axle holes?

I may need to get one ordered ASAP for Districts.

Thanks!

 

[Rocket car]

A #39 machinist drill bit(they have these at most hardware stores)it will get you 1.47degree cant. You really want a 3 degree cant in the rear. It will make the car faster and more stable. Use a #30 for that.

 

[shmrckx]

Thanks Rocket!

We made the car with the silver bullet and the included pin for 3 degree rears.

However, my son's car won his pack race but we just got the district rules and they require all four wheels to run flat to the track. So we are going to need to make some modifications to the car to comply with the district rules.

Doing some searches a lot of folks recommended going to 1.5 degree rears but no one included the pin size to set the silver bullet at the 1.5 degree angle.

Thanks again!