3m dry type spray verses Jig

[BulldogRacing]

So I ordered some 3m spray because I saw some guys used it as an alternative to the Jig. I used the DD4h process for axles and boars and oil. I ran my car and could not break 3.0, after cleaning the same wheels and axles and doing the process again but my jig came in and I ran 2.97 ad 2.98 depending on what drift I was at while tuning. So in my opinion the jig is well worth the effort of finding it. does anyone else have the same or different results? Did I miss a step that 3m may require? Also should the wheels cure in a warm temperature with the red rocket?

Jig 10+ 3M dry type spray 6.5

 

[W&K Creations]

I have a can of 3M spray but ive not used it.

I still use JIG. However, different people will let the JIG dry for different times....not sure if this has an impact in speed however I know it ranges from 10 minutes up to 24 hours from past posts.

And I know some have experimented with using heat to help "cure" the wax in the bore after the final polish but again ive not personal experience with it...

WK

 

[DEW36]

I use the 3M Silicone spray and had good results.

 

[BulldogRacing]

DEW36, do you use the 3m the same way as jig, maybe I did it wrong, thanks for the response.

 

[DEW36]

DEW36, do you use the 3m the same way as jig, maybe I did it wrong, thanks for the response.

I sprayed my axles and gave them a quick shake to remove the extra silicone and covered them. I left the axles dry for the same amount of time as my wheels for 24 hours. Hope this helps.