Here are some pics of the street stock car I am planning on building. I made it in Google SkectchUp, pretty cool program and it is free. I am just learning how to use it.
The black lines on the bottom of the car represent axle placement and wheel base. Rear axles are 5/32" from the bottom of the car, DFW is 3/32" and NDF is 4/32". Actual fender width will probably less that what you can see in those pictures. DFW side is narrowed 1/16" in front. The fenders show some extra lines on the sides of them I had to add to close the geometry so it would create a surface.
Updated bottom front pic to fix fender geometry, bottom angles were wrong.
Any thoughts, comments or suggestions for improvement are welcome.
right side
right side angle
left side
top
bottom
3/4 rear left
front bottom view
The black lines on the bottom of the car represent axle placement and wheel base. Rear axles are 5/32" from the bottom of the car, DFW is 3/32" and NDF is 4/32". Actual fender width will probably less that what you can see in those pictures. DFW side is narrowed 1/16" in front. The fenders show some extra lines on the sides of them I had to add to close the geometry so it would create a surface.
Updated bottom front pic to fix fender geometry, bottom angles were wrong.
Any thoughts, comments or suggestions for improvement are welcome.
right side

right side angle

left side

top

bottom

3/4 rear left

front bottom view
