Taking the plunge but need a shove.

[Guest]

Dang! I usually pop a brew after my heart gets racing from a scare too.

As you probably know from using a router:

It is not advisable to try to remove more material on one pass then a little less then half the diameter of the bit.

Perhaps your feed rate was too aggressive and it bogged down.

 

[ChrisF]

Why are there caterpillars lined up in formation on that block?

 

[Papa V Racing]

NG -

First glad your ok and didn't get to close to the things that matter most .. Your body parts.. Next I was going to ask if this was a new technique pouring some Ale into the lighting holes?? J/K ... DOn't waste a good brew on a Pine Car... Looking good so far.... Can't wait to see the finish project... What class will this end up in if you don't mind me asking....

Papa V

 

[ngyoung]

I'm entering the BSA class.

No more caterpillars.

 

[Guest]

Just curious, did you use expanding urethane foam in this?

 

[ngyoung]

It is whatever Great-Stuff is made out of.

 

[Guest]

JUS DO IT! YOU'S DONT NEED NO PUSH TO RACE TINEY TOY CARS! IT AINT ROCKET BIOLOGY!

 

[IAE Racing]

NG glad to hear no injury. I set up a fence on my drill table to use as a guide. I have also been known to use my Bullet to hold the work piece.